![](http://pdfasset.owneriq.net/0/5c/05c34016-41dd-4b7c-9ad7-086399a4b8ff/05c34016-41dd-4b7c-9ad7-086399a4b8ff-bg133.png)
Document No. 10-300077, Issue 2 10-7
Configuring Redundancy Options
Figure 10-4. Switch Fabric Status Web Page
CLI Command To enable the redundant hardware by using the CLI, enter the following
command from Enable/Configure mode:
(configure)# set fabric configure-redundant-hardware enable
Replacing the Primary Controller
If a Primary controller fails, notification is provided by:
■ An event log message
■ An error message that displays in the Switch controller field.