Filter
Top Products
Document No. 10-300077, Issue 2 15-15
Configuring the OSPF Routing Protocol
Deleting OSPF Virtual Links
You can delete OSPF Virtual links using either the Web Agent or the CLI.
Web Agent
Procedure
To delete an OSPF virtual link using the Web Agent:
1. In the navigation pane, expand the Routing > IP > OSPF folders, and
then click Virtual Links.
The OSPF Virtual Links Web page is displayed in the content pane. See
Figure 15-5.
2. Select the virtual link that you want to remove.
3. Click DELETE. The virtual link is removed.
CLI Command To delete an OSPF virtual link, use the following command:
(configure router:ospf)# [no] area <area-id> virtual-link
<router-id>
Modifying OSPF Virtual Links
You can modify OSPF virtual links using either the Web Agent or the CLI.
Web Agent
Procedure
To modify an OSPF virtual link using the Web Agent:
1. In the navigation pane, expand the Routing > IP > OSPF folders, and
then click Virtual Links.
The OSPF Virtual Links Web page is displayed in the content pane. See
Figure 15-5.
2. Select the virtual link that you want to modify.
3. See Table 15-4 to modify the OSPF Virtual Links Web page parameters.
4. Click APPLY to save your changes, or CANCEL to restore previous
settings.
CLI Command To modify an OSPF virtual link, use the following command:
(configure router:ospf)# area <area-id> virtual-link <router-
id> [hello-interval <seconds>] [retransmit-interval <seconds>] [dead-
interval <seconds>] [{authentication-key <key> | message-digest-key
<key-id> md5 <key>}]