Filter
Top Products
18-2 User Guide for the Avaya P580 and P882 Multiservice Switches, v6.1
Chapter 18
Figure 18-1. IPX SAP Interfaces Web Page
2. See Table 18-1 to configure the IPX SAP Interface Web page
parameters.
3. Click APPLY to save your changes, or CANCEL to restore previous
settings.
Table 18-1. IPX SAP Interface Web Page Parameters
Parameter Allows you to...
Select Select a SAP interface to modify.
Interface Identifies the IPX interface associated with the SAP
interface.
Network Number Identifies the number of the IPX network associated
with the interface.
Use Interpacket Gap Select one of the following from the pull-down menu:
• Disable – if you do not want the IPX SAP
periodic update packets to be sent out over an
interface with no interpacket transmission delay.
• Enable – If you want to send the IPX SAP
periodic update packets to be sent out over an
interface with an interpacket transmission delay
(default).
Use Max Packet Size Select one of the following from the pull-down menu:
• Disable – To limit SAP packets to 7 service
entries(default).
• Enable – To allow SAP) packets to contain the
maximum number of services entries that are
allowed by the SAP Interface MTU (default).
Periodic Update
Interval (sec)
Enter (in seconds) the interval at which periodic SAP
updates are sent out an interface. Default is 60 seconds.
1 of 2