Filter
Top Products
Changing the Primary Management Interface (pmi).
L The default pmi is the first interface you define.
To change the pmi:
1. Enter one of the interface contexts as explained before.
2. If there no ip assigned on that interface use the |
ip address <ip_ addr>< net- mask> command.
3. Use the ip routing-mode rt_primary_mgmt command to set the interface as pmi.
X The following message displays:
4. Enter the following commands:
copy running-config startup-config
reset
Establishing a Telnet Connection
Perform the following steps to establish a Telnet connection to the X330WAN for configuration
of WAN parameters. Telnet directly to one of the Router IP addresses:
1. Connect your station to the network.
2. Verify that you can communicate with the X330WAN using the ping command to the IP
address of the X330WAN you chose. If there is no response, check the IP address and
default gateway of both the X330WAN and the station.
3. From the Microsoft Windows® taskbar of your PC, click Start and then Run (or from the
DOS prompt of your PC), then start the Telnet session by typing:
telnet <X330WAN_IP_address>. For example: telnet 149.49.32.134.
LYou can also Telnet the IP address of the P330 stack. If you Telnet the IP address of the
stack, a connection is established with the Switch CLI entity of the Master module of the
stack. If you want to connect to the X330WAN CLI entity, use the
session [<mod_num> [wan]] command. If the IP address in the Telnet command is
the address of the X330WAN router, connection is established to the X330WAN CLI
entity.
4. When prompted for a Login Name, enter the default name root.
5. When prompted for a password, enter the User Level password root in lower case letters.
Do NOT use uppercase letters.
You can now configure the X330 WAN.
5
The primary management interface has changed. For this change to
take effect, you need to copy running- config startup- config
and then reset the device