Filter
Top Products
Insert the Module
To insert an X330WAN into an Avaya P330 switch:
1. Remove the blanking plate or other expansion module (if installed).
2. Insert the WAN expansion module gently into the slot, ensuring that the Printed Circuit
Board (PCB) is aligned with the guide rails.
L The PCB fits into the guide rails and not the metal base plate.
3. Press in the expansion module firmly until it is completely inserted into the Avaya P330
switch.
4. Gently tighten the two screws on the front panel of the expansion module by turning
them.
5. Power up the Avaya P330 switch.
X The self-test procedure starts. It takes between 30 to 60 seconds to complete.
X The LEDs on the X330WAN and the Avaya P330 switch should illuminate as shown
below:
Avaya X330WAN Expansion Module: Ten seconds after startup, the ALM LED
lights ON for ten seconds, then switches OF.F
The TST LED then lights for twenty
seconds and afterwards switches off.
Thirty seconds after startup, the ALM LED
lights ON again.
Avaya P330 Switch: LED Number 51 should be ON during the
self-test procedure.
L You can now safely connect the cables to the unit.
3
LED #51
ALM
TST
ACT
SIG
WAN LEDs