Filter
Top Products
5
Configure the Module
L Before you can set up the X330WAN module you must power on and set up the Avaya
P330 stack as described in the Avaya P330 User’s Guide.
L Before using the X330WAN module you must assign an IP address via the Command
Line Interface (CLI) or via a Telnet session to the switch where the X330 is inserted.
The following steps describe how to configure the X330WAN module using the Avaya CLI.
Establishing a Serial Connection
Perform the following steps to connect a terminal to the Console port of the X330WAN for
configuration of WAN parameters using the CLI:
1. Use the supplied serial cable to attach the RJ-45 console connector to the Console port.
Connect the DB-9 connector to the serial (COM) port on your PC/terminal.
2. Use the following serial port settings on the PC: 9600 baud, 8 bits, 1 stop bit and no parity.
If you connected a PC, run a VT-100 emulation session. (You can use the Windows®
HyperTerminal.)
LThe terminal connected to the serial port must be configured with the same settings; this
setting will work with any PC COM port over a DB9 to RJ45 connector.
3. Press Enter.
4. When prompted for a Login Name, enter the default name root.
5. When promoted for a password, enter the password root.
Establishing a Modem Connection
L A PPP connection with a modem can be established only after the X330WAN is config-
ured with an IP address and net-mask. Also, the parameters used in the X330WAN
must be compatible with the remote peer parameters.
L Commands are shown as follows: ip address; parameters which you need to enter
are shown in <> as follows: <net-mask>
LAll CLI commands mentioned in this section are described in the Avaya P330 Reference
Guide.
To configure a modem interface:
1. Connect a terminal to the Console port of the X330WAN as described in “Connecting the
Console Port”.
2. When prompted for a Login Name, enter the default name root and press Enter.
3. When prompted for a password, enter the password root and press Enter. You are now
in Supervisor mode.
4. At the prompt, type: interface Console and press Enter.
5. Use the ip address <ip_addr><net-mask> command entering an IP address and net-
mask to be used by the remote peer to connect via its console interface to the X330WAN.