Filter
Top Products
Configuring Loopback Interfaces
LAll CLI commands mentioned in this section are described in the Avaya P330 Reference
Guide.
To configure Loopback interfaces:
1. Use the interface loopback <loopback number> command to enter the Interface
Loopback mode. For example, typing interface loopback 1 configures a loopback
with a Loopback interface number 1.
The prompt changes to p330WAN-N(super-if:Loopbackn)#
where N is the switch number and n is the loopback interface number.
2. Use the ip address <ip_addr><net-mask> command to assign an IP address and
subnet mask to the interface.
3. Type exit to return to Supervisor mode. The prompt returns to p330WAN-N(super)#.
X The following displays:
4. Enter the following commands:
copy running-config startup-config
reset
Configuring Fast Ethernet Interfaces
LAll CLI commands mentioned in this section are described in the Avaya P330 Reference
Guide.
To configure Fast Ethernet interfaces:
1. Type interface FastEthernet 1 to enter the Interface Configuration mode.
The prompt changes to p330WAN-N(super-if:FastEthernet1)#.
2. Use the ip address <ip_addr><net-mask> command to assign an IP address and
subnet mask to the interface.
3. Type exit to return to Supervisor mode.
The prompt returns to p330WAN-N(super)#.
The primary management interface has changed. For this change to
take effect, you need to copy running-config startup-config and
then reset the device.
5