Filter
Top Products
User Manual Model 676 LOKPRINT® Maintenance •
••
• 37
7) Remove the old printhead carefully from the heat sink.
PRINTHEAD
HEAT SINK
8) Place the new print head onto the heat sink.
9) Replace the two print head mount screws. Be sure that the head is resting flat on
the heat sink before tightening these screws.
10) Replace the print head assembly in the printer, sliding screw / washer (Paragraph
4) into the holes in the mount plate. Make sure that the screw / washer slides all
the way to the front of the holder. Tighten screws.
HEAD TOUCHES
11) Reconnect the print head cable connectors, making sure that the connectors are
seated tightly.
NOTE: If the cable is not connected correctly, the print head will be destroyed when
the machine is powered on. Check to see that the cable is tight by observing
from underneath the print head. The cable’s connectors should be inside of
the connectors located on the print head.
12) Replace the media and ink and double-check your work. Power the machine on
and make sure that no adverse effects are noted. Before printing - the printhead
category must be set to match the new printheads mean resistance as labeled
on the head itself.
A) On the front panel arrow down to PRINT HEAD SETUP using the
MODE button and press ENTER.
B) Arrow down to HEAD CATEGORY for the print station you
replaced the head in.