Filter
Top Products
36 DSR1021/1022 Switch Installer/User Guide
a. Press Alt+Down Arrow to move the cursor down through the list of target devices.
b. Press Alt+Up Arrow to move the cursor up through the list of target devices.
c. Press Alt+Home to move the cursor to the first target device in the list.
d. Press Alt+End to move the cursor to the last target device in the list.
5. In the Time column, type the number of seconds (from 3-255) of desired time before the scan
moves to the next target device in the sequence.
6. Move the cursor to the next line or press Down Arrow and repeat steps 2-5 for each of the
remaining target devices to be included in the scan pattern.
7. Click OK to save settings.
To remove a target device from the Scan list:
1. In the Scan dialog box, click the target device to be removed.
2. Press Delete.
-or-
Press Shift+Delete to remove the selected target device and all entries below it.
3. Click OK to save settings.
To start the Scan mode:
1. If the OSCAR interface is not open, press Print Screen to open the Main dialog box. See
Figure 3.1 on page 21 for an illustration of the Main dialog box populated with sample data.
2. Click Commands to open the Commands dialog box as shown in Figure 3.12.
Figure 3.12: Commands Dialog Box