Filter
Top Products
Chapter 3: Accessing the PM IPDU via the Command Line Interface 17
Arguments
Examples
To get the current status for all units, enter:
To get the current status for a specific unit, enter:
To reset maximum current drawn, enter:
currentprotection
The currentprotection command turns the over current protection feature on or off. The overcurrent
protection does not allow an outlet to be turned on if the current drawn by the unit is greater than
the current threshold configured with the command alarm. This command may also be used to
display the current protection status and is available to the admin user only.
Syntax
currentprotection <on|off|status>
Arguments
Examples
To display current protection status for all units, enter:
<IPDU#> IPDU number in a daisy chain
<IPDU_ID>
Identification string previously set by the id command
reset
Clears the saved peak current value
<phase_letter>
Either phase X, Y or Z for the PM42 IPDU
pm>current
pm>current 2
pm>current reset
on
Enables over current protection
off
Disables over current protection
status
Displays the current protection status
pm>
currentprotection status