Filter
Top Products
Chapter 3: Accessing the PM IPDU via the Command Line Interface 23
humidity
The humidity command displays the PM IPDU’s surrounding humidity and the maximum humidity
the IPDU has registered (humidity peak). It may also be used to clear the saved peak
humidity value.
Syntax
humidity [<IPDU#>|<IPDU_ID>]|reset
Arguments
Examples
To get the humidity for all units in a daisy chain, enter:
To get the humidity for specific unit, provide the unit number as an argument, enter:
To reset the maximum humidity registered, enter:
hwocp
The hwocp command checks the status of the hardware overcurrent protection. When overcurrent
protection is on, the power is shut off. When the overcurrent protection is off or reset, the power is
on and the PM IPDU is running in normal mode. If no string identifying the IPDU is given, all PM
IPDUs in the daisy chain are affected by this command. This command is available to the admin
user only.
Syntax
hwocp [<IPDU#>|<IPDU_ID> [reset]]
<IPDU#>
IPDU number in a daisy chain
<IPDU_ID>
Identification string previously set by the id command
reset
Resets the maximum humidity registered
pm>humidity
pm>humidity 2
pm>humidity reset