Filter
Top Products
PS-24 Mains Adaptor
ENGLISH
Connect the AXIS 231D/232D power and alarm inputs/outputs
This document describes how to install the AXIS 231D/232D and the PS-24. Please refer to
the AXIS 231D/232D Installation Guide for further instructions.
Connect the dome camera to the power supply and alarm inputs/outputs* using the
connection cable supplied with the AXIS 231D/232D:
1. Disconnect the outer ring of the cable gland, thread the connection cable through the
outer ring and then through the cable gland.
2. For easy wiring, disconnect the terminal block connectors.
3. Following the pinout description on the power supply (inner lid), push the colored
wires into the corresponding pin holes in the connector and tighten the screws. It is
recommended that all wires are connected, even those that are not used in the
installation.
4. Connect any alarm inputs/outputs (input cables not supplied) to the corresponding
pin holes in the connector and fasten the screws.
5. Replace the connectors and replace and tighten the outer ring to secure the cable.
* alarm inputs e.g. doorbell, light and outputs e.g. alarm devices
See the Axis Web site at http://www.axis.com for more information about the available
outdoor housing and mounting accessories.