Filter
Top Products
42
Axxess
®
Model 8690 User Guide – ITP Mode
GETTING STARTED
Receiving Intercom Calls
Your endpoint can receive both intercom and non-handsfree intercom calls. If the
handsfree feature is enabled on your endpoint, intercom calls are automatically
answered. Non-handsfree intercom calls (see page 41) override the handsfree option.
If your handsfree feature is disabled, or if you receive a non-handsfree intercom call,
you must pick up the handset or press the
Answer button to answer the call.
When you use Unified Communicator to route incoming calls to your endpoint, calls
will always ring the endpoint, even if you have chosen to use the handsfree feature.
Without this initial ring, your endpoint would terminate the routing of the call, poten-
tially preventing you from receiving the call on a cell phone or other device while you
are away from your desk.
To enable or disable your endpoint’s handsfree answering feature:
With the handset in the cradle, dial
.
To receive an intercom call:
If the handsfree feature is enabled, the call is automatically answered.
If the handsfree feature is disabled, either press the
Answer button to answer the call,
or lift the handset for privacy.
To receive a non-handsfree intercom call:
EITHER, Press the
Answer.
OR, Lift the handset for privacy.
NOTE: You must lift the handset if the caller has the Ring Intercom Always feature
(377) enabled.
Instead of answering a ringing call, you can press one of the following menu but-
tons:
• SEND TO V-MAIL
: Sends the call directly to your voice mailbox. You will not
see this option if you do not have a mailbox.
• IC CALL TO DND
: Places your endpoint in DND mode and blocks the call.
(See page 56 for more information about DND mode.)
• SEND TO DEST
: Redirects the call to the intercom or outside number that you
enter. (See page 50 for more information about the Redirect Call feature.)
3 1 9