Filter
Top Products
User Manual MFGD 3420 8
To remove the strap:
1 Position the display with its rear side facing you.
2 If the foot cover is mounted on the foot, lift up the 2 clips of the foot
cover to release the cover from the foot.
3 Pull the lower side of the cover towards you and simultaneously
slide the cover downward.
4 Pull the red strap out of the fixation holes in the foot.
You can better leave the cover off the foot while connecting the signal
cables to the display.
2. INSTALLATION
2.1 Precautions
Keep your original packaging. It is designed for this display and is
the ideal protection during transport.
Avoid reflections in the flat panel to reduce eye strain.
Place the display on a strong and stable table or desk.
Keep the display away from heat sources and provide enough
ventilation in case it is built in a rack or console.
Make sure the computer is switched off before connecting the
signals.
Do not block or cover the openings in the external power supply
block. Also, do not turn the power supply upside down or at its
side. Doing so would cause overheating of the power supply.
2.2. Before installing the display
Important:
In the factory, the height-positioning system in the display foot is
blocked with a strap to prevent damage during transportation.
Before installing the display, you must remove this strap.