Barco R9002327 Projector User Manual


 
R5975059 BARCOVISION 708 MULTIMEDIA 200498 R5975059 BARCOVISION 708 MULTIMEDIA 200498
A-1 A-1
R5975059A BARCOVISION 708 200498 R5975059A BARCOVISION 708 200498
A-1 A-1
APPENDIX A : BATTERY REPLACEMENT IN THE RCU
Battery replacement in the RCU.
Contact
plate
Battery
fig.2
fig.1
APPENDIX A : BATTERY REPLACEMENT IN THE RCU
APPENDIX A : BATTERY REPLACEMENT IN THE RCU
Battery replacement in the RCU.
Contact
plate
Battery
fig.2
fig.1
APPENDIX A : BATTERY REPLACEMENT IN THE RCU
Remove the battery cover on the backside of the
remote control by pushing the indicated handle a little
to the bottom of the RCU. Lift up the top side of the cover
at the same time (fig. 1).
Remove the battery from the compartment and discon-
nect the contact plate (fig. 2).
Connect a new 9 V battery (type E-block, e.g. 6F22S
or equivalent) to the contact plate.
Insert the battery back into the compartment and put
the cover back.
Attention : when a new battery is installed, the projec-
tor address must be reprogrammed before using the
RCU.
Remove the battery cover on the backside of the
remote control by pushing the indicated handle a little
to the bottom of the RCU. Lift up the top side of the cover
at the same time (fig. 1).
Remove the battery from the compartment and discon-
nect the contact plate (fig. 2).
Connect a new 9 V battery (type E-block, e.g. 6F22S
or equivalent) to the contact plate.
Insert the battery back into the compartment and put
the cover back.
Attention : when a new battery is installed, the projec-
tor address must be reprogrammed before using the
RCU.
APPENDIX A : BATTERY REPLACEMENT IN THE RCU
Battery replacement in the RCU.
Contact
plate
Battery
fig.2
fig.1
APPENDIX A : BATTERY REPLACEMENT IN THE RCU
APPENDIX A : BATTERY REPLACEMENT IN THE RCU
Battery replacement in the RCU.
Contact
plate
Battery
fig.2
fig.1
APPENDIX A : BATTERY REPLACEMENT IN THE RCU
Remove the battery cover on the backside of the
remote control by pushing the indicated handle a little
to the bottom of the RCU. Lift up the top side of the cover
at the same time (fig. 1).
Remove the battery from the compartment and discon-
nect the contact plate (fig. 2).
Connect a new 9 V battery (type E-block, e.g. 6F22S
or equivalent) to the contact plate.
Insert the battery back into the compartment and put
the cover back.
Attention : when a new battery is installed, the projec-
tor address must be reprogrammed before using the
RCU.
Remove the battery cover on the backside of the
remote control by pushing the indicated handle a little
to the bottom of the RCU. Lift up the top side of the cover
at the same time (fig. 1).
Remove the battery from the compartment and discon-
nect the contact plate (fig. 2).
Connect a new 9 V battery (type E-block, e.g. 6F22S
or equivalent) to the contact plate.
Insert the battery back into the compartment and put
the cover back.
Attention : when a new battery is installed, the projec-
tor address must be reprogrammed before using the
RCU.