Filter
Top Products
3. Connections
1. Video
2. S-Video
3. 5 cable input
4. Computer input
SDI input is never automatically selected.
When a RCVDS is connected to the projector, the ’Automatic’ selection is disabled.
Setupoftheinputselection
1. Press ENTER to start up the adjustment mode.
2. Press the cursor keys to select Installation. (menu 3-2)
3. Press ENTER to display the Installation menu.
4. Press the cursor keys to select Input slots. (menu 3-3)
5. Press ENTER to display the Input Slots menu.
6. Press the cursor keys to select Slot Selector. (menu 3-4)
7. Press ENTER to toggle between [Manual] or [Automatic].
8. Press EXIT several times to leave the adjustment mode.
ADJUSTMENT MODE
Select a path from below :
RANDOM ACCESS
INSTALLATION
SERVICE
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 3-2
INSTALLATION
INPUT SLOTS
NO SIGNAL
LENS
MENU POSITION
QUICK ACCESS KEYS
800 PERIPHERAL
MORE..
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 3-3
INPUT SLOTS
SLOT SELECTOR [Automatic]
x 1. RGB [HS&VS]
- 2. RGB [HS&VS]
- 3. VIDEO
- 4. S-VIDEO
- 5. NO MODULE
- 6. NO MODULE
Select with ↑ or ↓
<ENTER> to toggle
<EXIT> to return
Menu 3-4
3.5.2 Inputs via RCVDS05
Overview
When using a RCVDS05, it is recommended to use a 5-cable output module in the RCVDS. The outputs of this module have to be
connected to the 5 cable input (slot 1) of the projector. To switch the projector in the 5-cable mode see chapter ’Installation mode’.
3.5.3 5–Cable input
Wheretofind?
Slot 1 has 5 BNC input terminals. These are in the left corner on the front panel.
16
R5976493 BARCOREALITY SIM 6 MK II 08092003