Filter
Top Products
DS-RPC Manual
11
Opening Menu Status
IMPORTANT: The Factory default serial communications parameters are 9600 bps, 8 data
bits, 1 stop bit, and no parity.
NOTE: The configuration menu is dependent on the specific host module installed.
If you have a proper connection to the unit upon power-up or unit reset, you should see something
similar to the following with the status menu:
NOTE: to get to the DS-RPC menu you may select the ‘C-Configuration’ option from the main
menu or select the DS-RPC option and then type ‘config’ at the prompt.
If a Managed User has been added, the unit will ask for user name.
Data Switch Series - F.3.10.4 (C) 2000 DS72 Bay Technical Associates
Unit ID: DS72 Network Interface
Enter username>admin
Enter password>******
Module:
Attention Character: ]
Device A ................1
Device B ................2
Device C ................3
Device D ................4
DS-RPC ................5
Configure.......................C
Status..........................S
Unit Reset......................RU
Logout..........................T
Enter Request :5
DS-RPC Series
(C) 2001 by BayTech
F2.03
Option(s) Installed:
True RMS Current
Internal Temperature
True RMS Voltage