Filter
Top Products
INSTALLATIONOVERVIEW
Pre-Configuration
The enclosure of the Switch is designed for rack-mount configuration in a standard
19-inch server rack. Rack-mount hardware is included for a sturdy rack installation.
Consider the following when deciding where to place the Switch:
• The location of your computers in relation to where you would like to install
your Switch; and
• The lengths of the cables you use to connect your computers to the Switch.
Cable Distance Recommendations
For PS/2 Computers
We recommend that PS/2 cable length be limited to 25 feet for best video
performance. Beyond that length, the probability of video degradation increases.
For USB Computers
We recommend that USB cable length be limited to 12 feet for best performance.
Beyond 12 feet, the probability of signal failure is likely, and this may cause the
device to fail.
Installing the Switch into a Server Rack
The included mounting brackets feature adjustable positions that allow the Switch to
fit in virtually any four-post, 19-inch server rack.
1. Remove the adjustable brackets from the box.
2. Select a bracket-hole scheme based upon your server rack’s dept.
3. Attach the bracket to the side of your Switch with the Phillips screws provided.
4. Mount the Switch to the rack rail assemblies.
Note: If this Switch will be daisy-chained to another KVM Switch, set the BANK address
prior to installing on a rack. Refer to the section in this User Manual labeled “Multiple
KVM Switch—Installation (Daisy-Chaining)”.
*** Cautions and Warnings ***
Before attempting to connect anything to the Switch or your computer(s), please
ensure that everything is powered off. Belkin Corporation is not responsible for damage
caused by these actions.
Glossary of Terms
The following definitions are used throughout the User Manual:
AutoScan A mode of operation where the KVM Switch sequentially monitors all
attached servers.
BANK The address of a KVM Switch when used in a daisy-chain configuration (BANK
numbers range from 0 to 15); typically set by adjusting the DIP Switch to the
appropriate setting.
Console The keyboard, video monitor, and mouse.
Console Ports The connectors on the back of the KVM Switch for connection of
the console.
Control In terms of switching between ports, “control” means that the console is
capable of sending input to the computer; requires that the console also has “focus”
on the port, and is “viewing” it.
Daisy-Chaining The process of connecting multiple KVM Switches together in a
sequence with cables. Daisy-chaining allows the KVM Switches to interact with each
other to expand control over servers.
Human Interface Device (HID) A USB device class that includes keyboards and mice.
IntelliView Graphical On-Screen Display (OSD) A graphical user interface that can
be used to control and configure the KVM Switch.
KVM or KVM Switch A keyboard, video, and mouse switch.
Port Receptacle in the KVM Switch for plugging in a computer or input device.
Primary Switch A KVM Switch with a console attached to it and set to BANK
address 0–3.
Secondary Switch Switches not assigned as “Primary Switch” that are connected in a
daisy-chained KVM configuration. These are set to BANK addresses 4–15 and do not
have a console connected directly to them.
Select Mode The mode of operation a daisy-chained KVM Switch enters when it
receives the first button press from the front panel, in Static mode. Select mode
allows the user to select BANKs, hosts, etc. with the next button press.
Standalone A single KVM Switch configured to function independently of other KVM
Switches.
Static Mode The KVM Switch’s predominant mode of operation, into which it enters
whenever it has not received a button press for at least five seconds.
View In terms of switching between ports, “viewing” means that the console is
receiving video from the computer. Viewing requires that the console also has
“focus” on the port.
6 7