Filter
Top Products
13
Using the Belkin Wireless Access Point Manager
Once you launch the WAP Manager Software, a window will open and begin
scanning for your WAP. The words "Scanning AP" will be displayed in the
bottom right corner of the window. When finished scanning, "Scanning
complete" will be displayed. You can connect to the WAP from any computer
on the network that is either wired or wireless. Your WAP is shipped from the
factory with the name "MiniAP". Instructions to change this are covered later in
this manual. If your WAP is installed properly, you should see the name
"MiniAP" in the “Wireless Manager” window when scanning has completed. If
not, see troubleshooting tips at the end of this manual.
Connecting to the WAP
To make any changes to the configuration of the WAP, you must connect to
the WAP by entering a password. The WAP is password-protected to keep
unauthorized users from changing settings.
1. Click on "Command" and select "Connect AP…" in the drop-down menu.