Belkin F5D7000 Network Card User Manual


 
INSTALLING AND SETTING UP THE CARD
11
11. Replace the computer’s cover.
12. Now that the Card is installed, you can replace the cover to your computer,
reconnect all of the cables, and turn it back on. Proceed to “Finishing the
Installation”.
Finishing the Installation
1. Turn your computer on.
2. Depending on your operating system, Windows OS may detect the Card and
launch the “Found New Hardware” wizard. Click “Next”.
INSTALLING AND SETTING UP THE CARD
Installing the Card into your PC for Windows 98, Me, 2000, and XP
1. POWER OFF THE COMPUTER AND DISCONNECT THE POWER CORD.
2. Remove the screws that secure the computer cover and remove the cover.
3. Touch any metal part of the case. This will discharge any static electricity that
could damage your product or your computer.
4. Locate an empty PCI expansion slot.
5. Confirm that the Card will fit into the slot you have chosen. Keep in mind
that the included antenna needs to be oriented with the top pointing up. If
there are cables and other connectors in the way, try to pick the PCI slot that
has the fewest obstructions to the correct positioning of the antenna.
6. Remove the port cover from the back of the PC that corresponds to the PCI
slot you selected. If there is a screw, place it in a safe place as you will be
using it to attach the Card to the computer chassis later.
7. Push the Card firmly into the PCI slot that you have chosen. Apply pressure as
needed until the connector is fully seated.
8. Now secure the Card with the screw that you previously placed in a safe place.
9. Carefully screw the antenna onto the threaded connector on the Card. Turn the
antenna until it is vertical and pointing up.
10 11