Filter
Top Products
2
22
Hardware Installation
2.4 Jumper Settings for Wake-On-PS/2
Keyboard/Mouse
Wake-On-PS/2 Keyboard/Mouse - Jumper JP1
The Wake-On-PS/2 Keyboard/Mouse function allows you to use the
PS/2 keyboard or PS/2 mouse to wake up the system from the S5
state. By default, JP1 is enabled. PS2KB Wakeup Select (IRQ/Event
Activity Detect field) in the Power Management Setup submenu of
the BIOS must be set accordingly. Refer to chapter 3 for details.
Warning:
1. If you forgot the password, you must power-off the system,
unplug the power cord and clear the CMOS data. Follow
the steps in the Jumper Settings for Clearing CMOS Data
section.
2. The 5VSB power source of your power supply must
support
≥
720mA.
2-3 On: Enable - 5VSB power
(default)
1-2 On: Disable - VCC power
3
2
1
3
2
1
1
2
3
Wake-On-PS/2
KB/Mouse (JP1)