Filter
Top Products
Maintenance 53
14. Restart the projector.
Do not turn the power on with the lamp cover removed.
15. After the startup logo, open the On-Screen
Display (OSD) menu. Go to the SYSTEM
SETUP: Advanced > Lamp Settings menu.
Press ENTER. The Lamp Settings page
displays. Highlight Reset Lamp Timer. A
warning message displays asking if you want
to reset the lamp timer. Highlight Reset and
press ENTER. The lamp time will be reset to '0'.
Do not reset if the lamp is not new or replaced as this could cause damage.
Temperature information
When the Temperature warning light is on, it is warning you of the following possible
problems:
1. The internal temperature is too high.
2. The fans are not working.
Turn the projector off and contact qualified service personnel for further help. For more
detailed information, please refer to "Indicators" on page 54.
9. Tighten the screw that secures the lamp.
• Loose screw may cause a bad connection, which
could result in malfunction.
• Do not over tighten the screw.
10. Connect the lamp connector to the projector.
11. Place the lamp cords back to the slots.
12. Replace the lamp cover on the projector.
13. Tighten the screws that secure the lamp cover.
• Loose screw may cause a bad connection, which
could result in malfunction.
• Do not over tighten the screw.
Reset Lamp Timer?
Reset
Cancel
Notice