Filter
Top Products
Operation 45
Shutting down the projector
1. Press Power and a confirmation message will
be displayed prompting you.
If you don't respond in a few seconds, the message
will disappear.
2. Press Power a second time. The POWER
indicator light flashes orange, the projection lamp
shuts down, and the fans will continue to run for
approximately 90 seconds to cool down the
projector.
To protect the lamp, the projector will not respond to any commands during the cooling
process.
To shorten the cooling time, you can also activate the Quick cooling function. See "Quick
Cooling" on page 51 for details.
3. Once the cooling process finishes, a "Power Off Ring
To n e " will be heard. The POWER indicator light is a
steady orange and fans stop. Disconnect the power
cord from the power outlet.
• To turn off the power ring tone, see "Turning off the Power
On/Off Ring Tone" on page 41 for details.
• If the projector is not properly shut down, to protect the
lamp, when you attempt to re-start the projector, the fans
will run for a few minutes to cool down. Press Power
again to start the projector after the fans stop and the
POWER indicator light turns orange.
• Lamp life results will vary depending on environmental
conditions and usage.
I
I
I
I
I
I