BenQ MP525 Projector User Manual


 
Operation 49
Description of each menu
Function Description
Wall Color
Corrects the projected picture's color when the projection
surface is not white. See "Using Wall Color" on page 33 for
details.
Aspect Ratio
There are four options to set the image's aspect ratio
depending on your input signal source. See "Selecting the
aspect ratio" on page 31 for details.
Keystone
Corrects any keystoning of the image. See "Correcting
keystone" on page 25 for details.
Position
Displays the position adjustment page. To move the projected
image, use the directional arrow keys. The values shown on the
lower position of the page change with every key press you
made until they reach their maximum or minimum.
This function is only available when a PC signal (analog
RGB) is selected.
Phase
Adjusts the clock phase to reduce image
distortion.
This function is only available when a
PC signal (analog RGB) is selected.
H. Size
Adjusts the horizontal width of the image.
This function is only available when a PC signal (analog
RGB) is selected.
Digital Zoom
Magnifies or reduces the projected image. See "Magnifying and
searching for details" on page 31 for details.
Picture Mode
Pre-defined picture modes are provided so you can optimize
your projector image set-up to suit your program type. See
"Selecting a picture mode" on page 33 for details.
Reference Mode
Selects a picture mode that best suits your need for the image
quality and further fine-tune the image based on the selections
listed on the same page below. See "Setting the User 1/User 2
mode" on page 34 for details.
Brightness
Adjusts the brightness of the image. See "Adjusting Brightness"
on page 34 for details.
Contrast
Adjusts the degree of difference between dark and light in the
image. See "Adjusting Contrast" on page 34 for details.
1. DISPLAY menu
2. PICTURE menu