Filter
Top Products
Operation46
English
Operating in a high altitude environment
We recommend you use the High Altitude Mode when your environment is between
1500 m –3000 m above sea level, and temperature is between 5°C–23°C.
Do not use the High Altitude Mode if your altitude is between 0 m and 1500 m and temperature
is between 5°C and 28°C. The projector will be over cooled, if you turn the mode on under
such a condition.
To activate the High Altitude Mode:
1. Press MENU/EXIT and then press /
until the SYSTEM SETUP: Advanced menu
is highlighted.
2. Press to highlight High Altitude Mode and
press / to select On. A confirmation
message displays.
3. Highlight Yes and press MODE/ENTER.
Operation under "High Altitude Mode" may cause a
higher decibel operating noise level because of increased fan speed necessary to improve
overall system cooling and performance.
If you use this projector under other extreme conditions excluding the above, it may display
auto shut-down symptoms, which is designed to protect your projector from over-heating.
In cases like this, you should switch to High Altitude mode to solve these symptoms.
However, this is not to state that this projector can operate under any and all harsh or
extreme conditions.
Creating your own startup screen
In addition to selecting the projector preset startup screen from among BenQ logo, Black or
Blue screen, you can make your own startup screen that is a picture projected from your
computer or video source.
To create your own startup screen, project the picture you want to use as your startup screen
from either a computer or video source. The rest steps are as follows.
1. Press MENU/EXIT and then press / until the SYSTEM SETUP: Basic menu
is highlighted.
2. Press to highlight My Screen and press ENTER.
3. A confirmation message displays. Press CAPTURE or ENTER again.
4. The message 'Screen Capturing...' displays while the projector is processing the
picture. Please wait.
5. If the action is successful, you see the message 'Captured Succeeded' on the screen.
The captured picture is saved as My Screen.
6. To view the captured picture displayed as the startup screen, set My Screen in the
SYSTEM SETUP: Basic > Splash Screen menu and restart the projector.
In the unlikely event that the capturing action fails, change your target picture.
We recommend you use the High Altitude
mode by selecting it whenever your
environment is higher than 1500m.
Yes
No
Notice
Do you want to turn High Altitude
Mode ON?