Filter
Top Products
Troubleshooting40
Troubleshooting
Related Messages
When the unit's power is on, messages such as those shown below may be displayed. When
any such message is displayed on the screen, please respond as described below. If the same
message is displayed after the treatment, or if a message other than the following appears,
please contact your dealer or service company.
memo Although these messages will be automatically disappeared around several minutes,
it will be reappeared every time the power is turned on.
(This table is continued to the following page.)
NOTE
• A lamp has a finite product life. Lamps are characterized by the fact that, after long
hours of usage, a lamp will no longer light up, or the lamp will break or burst, etc. This
projector is equipped with an automatic shut-down function, such that the power will
automatically be turned off when lamp usage time has reached 2000 hours. Please be
aware, however, that among lamp types, there are major differences in product
lifetimes; a lamp may thus fail to light even prior to the functioning of the automatic
shut-down function of this projector.
Message Description
CHANGE THE LAMP
AFTER REPLACING LAMP,
RESET THE LAMP TIMER.
The time the lamp timer has counted is
approaching 2000 hours.
Preparation of a new lamp, and an early lamp
change is recommended. After you have change
the lamp, please be sure to reset the lamp timer.
CHANGE THE LAMP
AFTER REPLACING LAMP,
RESET THE LAMP TIMER.
THE POWER WILL TURN OFF
AFTER ** hr.
The time the lamp timer has counted is
approaching 2000 hours, so a lamp change
within ** hours is recommended.
When lamp usage reaches 2000 hours, the power
will automatically be turned off.
Please change the lamp by referring to the section
“Lamp”. After you have changed the lamp, please
be sure to reset the lamp timer.
CHANGE THE LAMP
AFTER REPLACING LAMP,
RESET THE LAMP TIMER.
THE POWER WILL TURN OFF
AFTER 0 hr.
As the time the lamp timer has counted has
reached 2000 hours, the power will soon be
automatically turned off.
Please immediately turn the power off, and
change the lamp by referring to the section
“Lamp”. After changing the lamp, please be sure
to reset the lamp timer.
PB9200-e.book Page 40 Thursday, May 27, 2004 2:15 PM