Filter
Top Products
49
Maintenance
English
7. Lift the handle so that it stands up. Use the handle
to slowly pull the lamp out of the projector.
Pulling it too quickly may cause the lamp to
break and scatter broken glass in the
projector.
Do not place the lamp in locations where
water might splash on it, children can reach
it, or near flammable materials.
Do not insert your hands into the projector
after the lamp is removed. If you touch the
optical components inside, it could cause
color unevenness and distortion of the
projected pictures.
8. As shown in the figure, hold the new lamp and
align the two locators on the lamp with the holes
on the projector, and then insert the lamp all the
way into the projector.
9. Tighten the screw that secures the lamp.
10. Connect the lamp connector to the projector and
tighten the screw that secures the lamp connector.
Loose screw may cause a bad connection,
which could result in malfunction.
Do not over tighten the screw.
11. Ensure the handle is fully laid flat and locked in
place.
12. Replace the lamp cover on the projector.
13. Tighten the screw that secures the lamp cover.
Loose screw may cause a bad connection,
which could result in malfunction.
Do not over tighten the screw.
14. Restart the projector.
Do not turn the power on with the lamp cover
removed.
Resetting the corresponding lamp timer
15. After the startup logo, open the On-Screen
Display (OSD) menu.
Go to the SYSTEM SETUP: Advanced > Lamp
Settings menu.
Press ENTER and the Lamp Settings page
displays.
Highlight Reset Lamp #1 Timer/Reset Lamp #2
Timer. A warning message displays asking if you
want to reset the lamp timer.
Highlight Reset and press ENTER on the
projector or remote control. The lamp time will
be reset to '0'.
Do not reset if the lamp is not new or replaced
as this could cause damage.
2
1
Reset Lamp #1 Timer
Reset
Cancel
Notice