Filter
Top Products
Introduction12
Remote control effective range
The remote control must be held at an angle within 30 degrees perpendicular to the
projector's IR remote control sensor(s) to function correctly. The distance between the
remote control and the sensor(s) should not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote control and the IR sensor(s) on
the projector that might obstruct the infra-red beam.
15. MODE/ENTER
Selects an available picture setup mode.
Activates the selected On-Screen Display
(OSD) menu item.
16. SOURCE
Displays the source selection bar.
17. MIC/VOL +/MIC/VOL -
Adjusts the microphone input sound
level.
18. ASPECT
Selects the display aspect ratio.
19. MUTE
Toggles projector audio between on and
off.
20. SmartEco
The function is not available on this
projector.
21. TEST
Displays the test pattern.
22. Numeric buttons
Enters numbers in network settings.
Numeric buttons 1, 2, 3, 4 cannot be pressed when
asked to enter password.
Operating the LASER pointer
The Laser Pointer is a
presentation aid for professionals.
It emits a beam of red light when
you press it.
The laser beam is visible. It is
necessary to press and hold
LASER for continuous output.
Do not look into the laser light
window or shine the laser light beam on yourself or
others. See the warning messages on the back of the
remote control prior to using it.
The laser pointer is not a toy. Parents should be
mindful of the dangers of laser energy and keep
this remote control out of the reach of children.
• Operating the projector from the front
• Operating the projector from the rear
A
p
p
r
o
x
.
+
1
5
º
A
p
p
r
o
x
.
+
1
5
º