Filter
Top Products
Operation46
Function Description
Picture Mode
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See "Selecting a
picture mode" on page 31 for details.
Reference
Mode
Selects a picture mode that best suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See "Setting the User 1/User 2 mode" on page 31
for details.
Brightness
Adjusts the brightness of the image. See "Adjusting Brightness" on
page 32 for details.
Contrast
Adjusts the degree of difference between dark and light in the image.
See "Adjusting Contrast" on page 32 for details.
Color
Adjusts the color saturation level -- the amount of each color in a
video image. See "Adjusting Color" on page 32 for details.
This function is only available when a Video, S-Video or Component Video
signal is selected.
Tint
Adjusts the red and green color tones of the image. See "Adjusting
Tint" on page 32 for details.
This function is only available when a Video or S-Video signal is selected and
the system format is NTSC.
Sharpness
Adjusts the image to make it look sharper or softer. See "Adjusting
Sharpness" on page 32 for details.
This function is only available when a Video, S-Video or Component Video
signal is selected.
Brilliant Color
See "Adjusting Brilliant Color" on page 32 for details.
Color
Temperature
See "Selecting a Color Temperature" on page 32 for details.
Color
Temperature
Fine Tuning
See "Setting a preferred color temperature" on page 33 for details.
3D Color
Management
See "3D Color Management" on page 33 for details.
Reset Picture
Settings
See "Resetting current or all picture modes" on page 34 for details.
2. PICTURE menu