Filter
Top Products
Operation 31
Optimizing the image
Selecting a picture mode
The projector is preset with several predefined picture
modes so that you can choose one to suit your
operating environment and input signal picture type.
To select an operation mode that suits your need, you
can follow one of the following steps.
•Press MODE/ENTER on the remote control or
projector repeatedly until your desired mode is
selected.
•Go to the PICTURE: Basic > Picture Mode menu and press / to select a desired
mode.
The picture modes are listed below.
1. Dynamic mode: Maximizes the brightness of the projected image. This mode is
suitable for environments where extra-high brightness is required, such as using the
projector in well lit rooms.
2. Standard mode: Is designed for presentations. The brightness is emphasized in this
mode.
3. Cinema mode: Is appropriate for playing colorful movies, video clips from digital
cameras or DVs through the PC input for best viewing in a blackened (little light)
environment.
4. User 1/User 2/User 3 mode: Recalls the settings customized based on the current
available picture modes. See "Setting the User 1/User 2/User 3 mode" on page 31 for
details.
Setting the User 1/User 2/User 3 mode
There are two user-definable modes if the current available picture modes are not suitable
for your need. You can use one of the picture modes (except the User 1/User 2/User 3) as a
starting point and customize the settings.
1. Press MENU/EXIT to open the On-Screen Display (OSD) menu.
2. Go to the PICTURE: Basic: Basic > Picture Mode menu.
3. Press / to select User 1/ User 2/User 3.
4. Press to highlight Reference Mode.
This function is only available when User 1/User 2/User 3 mode is selected up in the Picture
Mode sub-menu item.
5. Press / to select a picture mode that is closest to your need.
6. Press to select a sub-menu item to be changed and adjust the value with / .
See "Fine-tuning the image quality" below for details.
7. When all settings have been done, highlight Save Settings and press MODE/ENTER to
store the settings.
8. The confirmation message 'Setting Saved' displays.
The User 1/User 2/User 3 functions can also be accessible by pressing
USER-1/USER-2/USER-3 on the remote control.