Filter
Top Products
Operation 43
Description of each menu
• The default values listed in this manual, especially on pages 43-48, are for reference only.
They may vary between the projectors due to the continuous improvement to the
products.
FUNCTION DESCRIPTION
Picture Mode
Pre-defined picture modes are provided so you can optimize your
projector image set-up to suit your program type. See "Selecting a
picture mode" on page 31 for details.
Reference
Mode
Selects a picture mode that best suits your need for the image quality
and further fine-tune the image based on the selections listed on the
same page below. See "Setting the User 1/User 2/User 3 mode" on page
31 for details.
Brightness
Adjusts the brightness of the image. See "Adjusting Brightness" on
page 32 for details.
Contrast
Adjusts the degree of difference between dark and light in the image.
See"Adjusting Contrast" on page 32 for details.
Color
Adjusts the color saturation level -- the amount of each color in a
video image. See "Adjusting Color" on page 32 for details.
This function is only available when Video or S-Video with NTSC
system is selected.
Tint
Adjusts the red and green color tones of the image. See "Adjusting
Tint" on page 32 for details.
This function is only available when Video or S-Video with NTSC
system is selected.
Sharpness
Adjusts the image to make it look sharper or softer. See "Adjusting
Sharpness" on page 32 for details.
This function is only available when Video or S-Video with NTSC
system is selected.
Flesh Tone
See "Adjusting Flesh Tone" on page 32 for details.
Save Setting
Saves the settings made for User 1 or User 2 or User 3 mode.
Reset Picture
Settings
Resets the picture settings for User 1 or User 2 or User 3 mode.
1. PICTURE: Basic menu