Filter
Top Products
Operation 35
6. Press to highlight Gain and adjust its values to your preference by pressing / .
The contrast level of the primary color you select will be affected. Every adjustment
made will reflect to the image immediately.
7. Repeat steps 3 to 6 for other color adjustments.
8. Make sure you have made all of the desired adjustments.
9. Press MENU/EXIT to exit and save the settings.
Selecting a Film Mode
Highlight Film Mode in the PICTURE: Advanced menu and select by pressing / on
the projector or remote control.
On is the default and recommended selection for this projector. When Off is selected, the
Film Mode function is not available.
This function is only available when Video or S-Video with NTSC system is selected.
Selecting a 3D Comb Filter
Highlight 3D Comb Filter in the PICTURE: Advanced menu and select by pressing /
on the projector or remote control.
3D Comb Filer separates the Y and C signals while simultaneously processing three
consecutive horizontal scan lines. While comparing three consecutive horizontal scan lines
within a single video frame, it also analyzes each frame in advance, ensuring the best
possible picture.
On is the default and recommended selection for this projector. When Off is selected, the 3D
Comb Filter function is not available.
This function is only available when Video or S-Video with NTSC system is selected.
Hiding the image
In order to draw the audience's full attention to the
presenter, you can use BLANK on the projector or
remote control to hide the screen image. Press any key
on the projector or remote control to restore the image.
The word 'BLANK' appears at the screen while the
image is hidden. When this function is activated with
an audio input connected, the audio can still be heard.
You can set the blank time in the
SYSTEM SETUP >
Operation Settings > Blank Timer menu to let the projector return the image automatically
after a period of time when there is no action taken on the blank screen. The length of time
can be set from 5 to 30 minutes in 5-minute increments.
Do not block the projection lens from projecting as this could cause the blocking object to
become heated.
Setting the Sleep Timer
You can set the Sleep Timer interval so the projector powers off after the specified time
period of inactivity (regardless of signal).
Set the sleep timer in the
SYSTEM SETUP > Operation Settings > Sleep Timer from among
Disable/30 min/1 hr/2 hr/3 hr/4 hr/8 hr/ 12hr.
Freezing the image