Filter
Top Products
21
Using the projector
English
Selecting an input source
The projector can be connected to multiple equipment at the same time.
When the projector is first turned on, it will attempt to reconnect with the
input source which was in use when the projector was last shut down.
To s el ect the vi de o sou rce :
• Using the remote control or projector
Press one of the Source keys on the remote control, or press SOURCE on
the projector repeatedly until your desired signal is selected.
• Using the OSD menu
1. Press MENU and then press / until the System Setup menu is
highlighted.
2. Press to highlight Input Source and press ENTER. The source
selection bar displays.
3. Press / repeatedly until your desired signal is selected and press
ENTER.
Once detected, the selected source information will display on the
screen for seconds. If there are multiple pieces of equipment
connected to the projector, you can go back to the source selection bar
again to search for other signals.
• If you want the projector to automatically search for the signals, select
On in the System Setup > Auto Source Search menu.
• If you want to use the PIP function, see "Displaying more than one
image source simultaneously" on page 35 for details.
Fine-tuning the image size and clarity
Language
Splash Screen
Projector Position
Auto Off
Sleep Timer
Background Color
Menu Settings
Input Source
System Setup
S-Video
English
BenQ
Auto Source Search
EXIT Back
Disable
Disable
Blue
On
Floor Front
ENTER
NOTE: When
automatically
searching for a
valid input
source, the
projector cycles
through the
available signals
following the
sequence from
top to bottom as
the source
selection bar
shows.
1. Adjust the projected picture to the size that
you need using the zoom ring.
2. Sharpen the picture by rotating the focus
ring.