Filter
Top Products
36
Using the projector
English
Personalizing the projector menu display
The On-Screen Display (OSD) menus can be set according to your preferences. The following settings do
not affect the projection settings, operation, or performance.
• Rename User Mode: See "Renaming user modes" on page 27 for details.
• Menu Display Time in the System Setup > Menu Settings menu sets the length of time the OSD will
remain active after your last key press. The time length ranges from 5 to 30 seconds in 5-second
increments. Use / to select a suitable time length.
• Menu Position in the System Setup > Menu Settings menu sets the OSD position in five locations. Use
/ to select a preferred position.
• Language in the System Setup menu sets your familiar language for the On-Screen (OSD) Menus. See
"Using the menus" on page 22 for details.
• Splash Screen in the System Setup menu sets a preferred logo screen to be displayed during projector
start-up.
Locking control keys
With the control keys on the remote control and projector locked, you can prevent your projector settings
from being changed accidentally (by children, for example). When Key Lock is on, no control keys on the
remote control and projector will operate except POWER ON/OFF and EXIT.
To lock t he ke ys:
1. Press MENU and then press / until the Advanced Setup menu is
highlighted.
2. Press to highlight Key Lock, and press ENTER. The control keys
lock.
To unlock the keys, press and hold EXIT on the projector or remote
control for 5 seconds.
Tu r ni n g th e p ro je c t or of f
To turn the projector off, press POWER OFF on the remote control
to turn the projector off directly. Or you can press on the
projector and a warning message appears. Press again.
• The Power indicator light flashes orange and the fans run for
about two minutes to cool the lamp. The projector will not
respond to any commands until the cooling process is complete.
• Then, the Power indicator light is a steady orange once the
cooling process has finished and fans stop.
• If the projector will not be used for an extended period, unplug
the power cable from the power outlet.
• To protect the lamp, the projector will not respond to any
commands during the cooling process.
Lamp Settings
Test Pattern
High Altitude Mode
Password
Key Lock
Reset All Settings
Advanced Setup
EXIT Back
S-Video
ENTER
Off
HDMI Settings
ISF
Baud Rate 115200
Press button again to power off.
Power Off
Press any other button to cancel
I
I
I
I