Filter
Top Products
Billion 400G
Router
Chapter 3: Basic Installation
13
Factory Default Settings
Before configuring your, you need to know the following default settings.
Web Interface (Username and Password)
Username: admin
Password: admin
The default username and password are “admin” and “admin” respectively.
Device LAN IP settings
IP Address: 10.0.0.2
Subnet Mask: 255.255.255.0
ISP setting in WAN site
PPPoE
DHCP server
DHCP server is enabled.
Start IP Address: 10.0.0.100
IP pool counts: 100
LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
LAN Port
WAN Port
IP address
10.0.0.2
The
WAN protocol has been
pre-selected and set by Telkom
for automated service
deployment and delivery.
Subnet Mask
255.255.255.0
DHCP server function
Enabled
IP addresses for distribution
to PCs
100 IP addresses continuing from
10.0.0.100 through 10.0.0.199
Attention
If you ever forget the username/password to login to the router, you may press the
RESET button for 6 – 8 seconds to restore the factory default settings.
Caution: After pressing the RESET button for more than 6 seconds, to be sure you power
cycle the device again.
Attention