Filter
Top Products
Billion 400G
Router
Chapter 4: Configuration
50
MSN (1863) TCP(6) 1863 1863 YES YES N/A N/A N/A N/A
MSN (7001) UDP(17) 7001 7001 YES YES N/A N/A N/A N/A
MSN VEDIO
(9000)
TCP(6) 9000 9000 NO YES N/A N/A N/A N/A
Inbound: Internet to LAN ; Outbound: LAN to Internet.
YES: Allowed ; NO: Blocked ; N/A: Not Applicable
Packet Filter – Add TCP/UDP Filter
Rule Name: Users-define description to identify this entry or click “Select” drop-down menu to select existing
predefined rules. The maximum name length is 32 characters.
Time Schedule: It is self-defined time period. You may specify a time schedule for your prioritization policy. For
setup and detail, refer to Time Schedule section
Source IP Address(es) / Destination IP Address(es): This is the Address-Filter used to allow or block traffic
to/from particular IP address(es). Selecting the Subnet Mask of the IP address range you wish to allow/block the
traffic to or form; set IP address and Subnet Mask to 0.0.0.0 to inactive the Address-Filter rule.
Tip: To block access, to/from a single IP address, enter that IP address as the Host IP Address and use a Host
Subnet Mask of “255.255.255.255”.
Source Port: This Port or Port Range defines the port allowed to be used by the Remote/WAN to connect to the
application. Default is set from range 0 ~ 65535. It is recommended that this option only be configured by advanced
users.
Destination Port: This is the Port or Port Ranges that define the application.
Type: It is the packet protocol type used by the application, select TCP, UDP or both TCP/UDP. Protocol Number:
Insert the port number.
Inbound / Outbound: Select Allow or Block the access to the Internet (“Outbound”) or from the Internet
(“Inbound”).
Click Add button to apply your changes
.