Filter
Top Products
17
CHAPTER 3: Configuration
3. Configuration
The ServSwitch USB comes from the factory preset to default configuration
settings which are suitable for most applications. You can set the Switch differently
by moving the positions of the configuration DIP switch on the bottom of the
ServSwitch USB, shown in Figure 3-1 below, to different settings.
Figure 3-1. The configuration DIP switch.
ON DIP
1 2 3 4 5 6 7 8
Positions 1 and 2:
Hotkey combination
(ServSwitch USB Plus
only; see Section 3.4)
Position 3:
Mouse switching
(ServSwitch USB Plus
only; see Section 3.5)
Position 4:
Reserved for future
use (do not change
its setting)
Positions 5 and 6:
Enumeration guard time
(see Section 3.1)
Position 8:
Ports to scan and
cycle to (see
Section 3.3)
Position 7:
Autoscan pause time
(see Section 3.2)