Filter
Top Products
38
LINESHARE PRO
The following sections contain
specific information about each
feature and function and how to
change the setting.
5.4 Changing ON/OFF features
Earlier in this chapter, Table 5-1
listed the features that can be turned
ON or OFF individually, or
simultaneously with other features
during a single programming
session. The features are numbered
[0] through [9]. In this section, you
will find a description of each
feature and instructions for turning
the feature ON or OFF.
To turn a feature ON or OFF, use
the following steps:
1. Press # * from a tone phone
connected to Port 1 to enter the
programming mode.
2. Turn the feature ON by pressing
1 followed by the feature
number. Turn the feature OFF
by pressing 0 followed by the
feature number.
3. Press * to end the programming
sequence.
4. Continue performing steps 2
and 3 until all the desired
features have been changed.
NOTE
You have 5 seconds between
each tone entry to enter
another command. If you do
not enter a command within
5 seconds, the Lineshare Pro
exits the programming mode
without saving the changes.
5. When you are finished making
changes, press the * key again to
save the changes and exit the
programming mode.
Example: To turn Home Routing ON,
enter the programming mode and
press 1 1 *. Press * again to save the
changes, and exit the programming
mode. To turn Home Routing OFF,
enter the programming mode and
press 0 1 *. Press * again to save the
changes, and exit the programming
mode.
[0] Extension Detection
Extension Detection operates only
when the Lineshare Pro is
configured in the non-secured
mode, and when an inbound
telephone call is ringing PORT 1 (or
the primary default port).
This feature allows the Lineshare
Pro to detect when an extension
phone not directly connected to the
Lineshare Pro answers a call that is
actively ringing the primary default
port. When the Lineshare Pro
detects that the extension phone has
gone off-hook, it releases the call to
the extension phone and stops
ringing the primary default port.
The Extension Detection feature is