Filter
Top Products
44
LINESHARE PRO
[2] [1] Protocol Tone Access Signal
Detection
Protocol Tone Access Signal
Detection allows you to turn ON or
OFF each port’s ability to detect
single-frequency routing tones.
Setting the options for this function
can be performed in two ways:
• Setting an individual port ON or
OFF.
• Setting all ports ON or OFF in
one programming sequence.
The Protocol Tone Access Signal
Detection is factory-preset as follows
(the first number is the
corresponding port number; the
second number is 0 for OFF, or 1 for
ON):
1 0 * (Port 1 = OFF)
2 0 * (Port 2 = OFF)
3 1 * (Port 3 = ON)
4 1 * (Port 4 = ON)
To change one port to detect
single-frequency tones, enter the
programming mode and press the
following on your tone phone:
2 1 Protocol Tone Access Signal
Detection
The desired port selection (1-4)
1 Turn ON
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming
To change all ports to detect
single frequency tones, enter the
programming mode and press the
following on your tone phone:
2 1 Protocol Tone Access Signal
Detection
0 Select all ports 1 through 4
1 1 1 1 All ports ON
* End programming sequence (3
beeps indicate correct entry)
(Optional entries for additional
changes)
* Save changes and exit
programming
[2] [2] Dual Tone Detection
Dual Tone Detection allows you to
turn ON or OFF each port’s ability
to detect dual tones (access codes).
Setting the options for this function
can be performed in two ways.
• Setting an individual port ON or
OFF.
• Setting all ports ON or OFF in
one programming sequence.