724-746-5500 | blackbox.com
Page 40
EME144A-R2
724-746-5500 | blackbox.com
Chapter 3: Installation
NOTE: As with all the other sensors, you can now set up the sound detector to be attached to a notification. Then, when your
thresholds are broken, it will trigger a specified type of notification.
3.8 Expansion Ports
The ServSensor has two expansion ports that enable you to connect up to two daisychainable expansion modules. The available
expansion modules are an 8-port intelligent sensor board (EME1X8) and an opto-isolated (16) dry-contact expansion module
(EME1DC16). In this section, we will go through the basic setup of the 8-port intelligent sensor board. If you need information on
specific functions of a particular sensor or expansion board, then please refer to the relevant manual for that product.
1. Plug the expansion board into one of the two ports located on the front panel of the unit. These are numbered E1 and E2. See
Figure 3-50.
Figure 3-50. Plug expansion boards into these ports.
2. From the summary page, navigate to the “Sensors” tab. Then click “Extended port” as outlined in Figure 3-51.
Figure 3-51. Sensors tab, extended port option.