Filter
Top Products
Multimedia LCD P
r
o
j
ecto
r
Turning
of
f
the
projector
1. Press the power button on the projector or r emote control. The power off
confirmation message appears .I f you do not wan t to power off the
projector, ignore the message and it will disappear.
2. Press the powe
r
button again and the pro
j
ec
t
or will enter cool-down
mode. The lamp shuts off, the lamp indicator flashes red, and the fans
continue to run for approximately two minutes. During the cool down
sequence the projector will not respond to any control panel or remote
control buttons.
Caution: Do not set the
p
ower switch to of
f
or un
p
lug the
p
rojector durin
g
the
cool-down sequence. Not allowing the lamp to cool properly will greatly reduce the
life of the lamp.
3.
A
fter the cool-down sequence is complete the fans will shut off and the
lamp indicator will stop flashing. The projector is now in standby mode
and can be turned back on with the remote control or control panel. If the
projector will not be used for an extended period, set the power switch to
off and disconnect the power cord.
-32
-