Filter
Top Products
9
Setting Up
Read the following sets of instructions to learn how to connect the battery pack/charger,
install a print ribbon cartridge, and install a roll of labels.
Using the Battery Pack and Charger
The TLS2200™ Thermal Labeling System is shipped with a battery pack and a battery
charger unit. Use these items to power the unit as shown below:
NOTES: The battery pack is shipped in an uncharged condition. Charge the battery for a
minimum of 5 hours before operating the printer solely on battery power.
You can charge the battery pack while the printer is turned “On” or “Off.” The
battery pack will be charging as long as the charger is plugged in.
Brady recommends, however, that once the battery pack is fully charged, you should
unplug the charger and operate the printer solely on battery power.
If the battery pack is completely discharged, connecting the charger does not
provide enough power to run the printer. Recharge the battery pack before
continued use.
Disposal of the Battery Pack
The NiCad battery pack contains cadmium, a toxic element. The battery pack is
considered hazardous toxic waste and must not be thrown away in the home or office
garbage. Once the useful life of the battery is ended (1-3 years), contact your local
authorities for information regarding its proper disposal or recycling options.
Battery Charger Jack
Connect the charger unit here.
You can charge the battery
pack while it is either installed
or removed from the printer.
Power Switch
Turns the printer
ON and OFF
Sliding Lever
Use to lock the battery pack
in place during installation
or to release it for removal.
Battery Pack
Install as shown.