Filter
Top Products
30
Creating a Wiremarker
Legend to be printed: 1001
Setup Status:
H Justify: Center
V Justify: Center
Rotation: 0 Degrees
Format: Component
1. Press <Shift> + <Form Clear> to delete all lines of text and reset the font to the default
value of 9.
2. Press <Shift> + <0> to change Format mode from “Component” to “Wire” (note change
from “C” to “W” on Status Bar on LCD).
3. Enter 1001on line 1.
4. Press <Print>.
Creating Serialized Wiremarkers
Legends to be printed: A201 A202 A203 A204 A205
Setup Status:
H Justify: Center
V Justify: Center
Rotation: 0 Degrees
Format: Wire
1. Press <Legend Clear> to clear the text from line 1.
2. Check the STATUS BAR to make sure the unit is in Wiremarker mode. If not, press
<Shift> + <0> to toggle from Component mode to Wiremarker mode.
3. Enter A201on line 1.
4. Press < = > to position the cursor under the last character.
5. Press <Func> + <Serial>.
6. When “No. to Serial? “ prompt appears, enter 5 , then press <Enter>.
7. When “No. of Copies?” prompt appears, enter 2
8. Press <Enter> or <Print>. The printer will begin printing two each of the five
wiremarkers listed above.