Filter
Top Products
KEYPAD
ECM (Error Correction Mode)
ECM automatically reduces the possibility of
damaged data when sending or receiving faxes.
ECM is switched on and we recommend that you
do not change this setting.
PaperJet 300 user guide ~ Edition 3.2 ~ 25th july ’01 ~ 3693
45
Power Save mode
The power save feature reduces power consumption
from 6W to 2W while your PaperJet 300 is lying idle.
Power save is switched off when you receive your
machine.
You can switch power save on and off by changing
the feature setting 13, see list on page 42. The power
save setting will switch on about 5 minutes after the
last button has been pressed or the last call was
received. The display shows
POWER SAVE
.
Power save will automatically switch off again, when
a button is pressed, the handset is lifted or a new
call is received.
Power save mode does not switch on if the display
shows
NEW CALLS
or if you have a colour cartridge
installed.
To reduce the printing area
If someone is trying to send you a fax that
is longer than the paper you are printing on,
your PaperJet 300 will try to receive it over
2 pages. You can reduce the printing area in
order to compress the fax onto a single page.
All faxes are reduced. Your PaperJet 300
has been originally set to 90% of the original
size, but incoming faxes can be switched
between 90%, 84% or 70%. You must re-set
the reduction again to change it back.
Press Function until the display shows
5: FAX SET UP?
Press Enter.
Display shows
1: SET CLOCK?
Press Function until the display shows
3: SETTINGS?
Press Enter.
Press Function until display shows
PRINT
SIZE
(or enter 5, 5 to go straight there).
Press Enter.
Set the ratio you want
00 = 90%
01 = 84%
02 = 70%
Press Enter to confirm.
Press Stop to return to standby.
IMPORTANT
If you have connected your PaperJet 300 to a
computer and it has gone into power save mode,
you will not be able to print until power save is
deactivated. You can only deactivate power save by
pressing a button on your PaperJet 300 or by lifting
the handset. Power save cannot be deactivated
through a command from your computer.
KEYPAD
Stop