Filter
Top Products
Converged Enhanced Ethernet Administrator’s Guide 97
53-1002163-02
LLDP configuration and management
9
DRAFT: BROCADE CONFIDENTIAL
9. Advertise the LLDP DCBX-related TLVs.
switch(conf-lldp-profile-UK_LLDP_IT)#advertise dot1-tlv
switch(conf-lldp-profile-UK_LLDP_IT)#advertise dot3-tlv
switch(conf-lldp-profile-UK_LLDP_IT)#advertise advertise dcbx-tlv
switch(conf-lldp-profile-UK_LLDP_IT)#advertise dcbx-fcoe-logical-link-tlv
switch(conf-lldp-profile-UK_LLDP_IT)#advertise dcbx-fcoe-app-tlv
switch(conf-lldp-profile-UK_LLDP_IT)#advertise dcbx-isci-app-tlv
NOTE
Brocade recommends against advertising dot1.tlv and dot3.tlv LLDPs if your network contains
CNAs from non-Brocade vendors,. This configuration may cause functionality problems.
10. Enter the copy command to save the running-config file to the startup-config file.
switch(conf-lldp-profile-UK_LLDP_IT)#do copy running-config startup-config
Configuring the iSCSI profile
You can configure an iSCSI profile to be applied to individual interfaces. However, the priority bit
must be set manually for each interface. Using the no profile name command deletes the entire
profile.
To configure iSCSI profiles, perform the following steps from privileged EXEC mode.
1. Use the cee-map command to create the cee profile, if it has not already been created.
switch(config)#cee-map
switch(conf-ceemap)#priority-group-table 1 weight 50
switch(conf-ceemap)#priority-group-table 2 weight 30 pfc
switch(conf-ceemap)#priority-group-table 3 weight 20 pfc
switch(conf-ceemap)#priority-table 1 1 1 1 2 3 1 1
2. Enter LLDP configuration mode.
switch(conf-ceemap)#protocol lldp
3. Create an LLDP profile for iSCSI.
switch(conf-lldp)#profile iscsi_config
4. Advertise the iSCSI TLV.
switch(conf-lldp-profile-iscsi_config)#advertise dcbx-iscsi-app-tlv
5. Enter configuration mode for the specific interface.
switch (conf-lldp-profile-iscsi_config)#interface te 0/1
6. Apply the CEE Provisioning map to the interface.
switch(conf-if-te-0/1)#cee default
7. Apply the LLDP profile you created for iSCSI.
switch(conf-if-te-0/1)#lldp profile iscsi_config
8. Set the iSCSI priority bits for the interface.
switch(conf-if-te-0/1)#iscsi-priority-bits list 6
9. Repeat steps 5 through 7 for additional interfaces.
switch(conf-if-te-0/1)#interface te 0/7
switch(conf-if-te-0/7)#cee default
switch(conf-if-te-0/7)#lldp profile iscsi_config
switch(conf-if-te-0/7)#iscsi-priority-bits list 6