Filter
Top Products
Converged Enhanced Ethernet Administrator’s Guide 123
53-1002163-02
DRAFT: BROCADE CONFIDENTIAL
Chapter
12
Configuring 802.1x Port Authentication
In this chapter
•802.1x protocol overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 123
•802.1x configuration guidelines and restrictions . . . . . . . . . . . . . . . . . . . . 123
•802.1x authentication configuration tasks . . . . . . . . . . . . . . . . . . . . . . . . . 124
•Interface-specific administrative tasks for 802.1x . . . . . . . . . . . . . . . . . . . 124
802.1x protocol overview
The 802.1x protocol defines a port-based authentication algorithm involving network data
communication between client-based supplicant software, an authentication database on a server,
and the authenticator device. In this situation the authenticator device is the Brocade FCoE
hardware.
As the authenticator, the Brocade FCoE hardware prevents unauthorized network access. Upon
detection of the new supplicant, the Brocade FCoE hardware enables the port and marks it
“unauthorized”. In this state, only 802.1x traffic is allowed. All other traffic, such as DHCP and
HTTP, is blocked. The Brocade FCoE hardware transmits an EAP-request to the supplicant, which
responds with the EAP-response packet. The Brocade FCoE hardware, which then forwards the
EAP-response packet to the RADIUS authentication server. If the credentials are validated by the
RADIUS server database, the supplicant may access the protected network resources.
NOTE
802.1x port authentication is not supported by LAG (Link Aggregation Group) or interfaces that
participate in a LAG.
NOTE
The EAP-MD5, EAP-TLS, EAP-TTLS and PEAP-v0 protocols are supported by the RADIUS server and
are transparent to the authenticator switch.
When the supplicant logs off, it sends an EAP-logoff message to the Brocade FCoE hardware which
then sets the port back to the “unauthorized” state.
802.1x configuration guidelines and restrictions
Follow these 802.1x configuration guidelines and restrictions when configuring 802.1x:
• If you globally disable 802.1x, then all interface ports with 802.1x authentication enabled
automatically switch to force-authorized port-control mode.