Filter
Top Products
Converged Enhanced Ethernet Administrator’s Guide 53
53-1002163-02
Configuring protocol-based VLAN classifier rules
6
DRAFT: BROCADE CONFIDENTIAL
NOTE
FCoE Initialization Protocol (FIP) and FCoE cannot be manually configured in VLAN classifier rules.
They are part of the fcoeport interface configuration and are applied automatically when an
interface is configured as fcoeport.
For complete information on all available VLAN classifier rule options, see the Converged Enhanced
Ethernet Command Reference.
Configuring a VLAN classifier rule
To configure a protocol-based VLAN classifier rule, perform the following steps from privileged EXEC
mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the vlan classifier rule command to configure a protocol-based VLAN classifier rule.
switch(config)#vlan classifier rule 1 proto ip encap ethv2
Configuring MAC address-based VLAN classifier rules
To configure a MAC address-based VLAN classifier rule, perform the following steps from privileged
EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the vlan classifier rule command to configure a MAC address-based VLAN classifier rule.
switch(config)#vlan classifier rule 5 mac 0008.744c.7fid
Deleting a VLAN classifier rule
VLAN classifier groups (1 through 16) can contain any number of VLAN classifier rules.
To configure a VLAN classifier group and remove a VLAN classifier rule, perform the following steps
from privileged EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
2. Specify a VLAN classifier group and delete a rule.
switch(config)#no vlan classifier rule 1
Creating a VLAN classifier group and adding rules
VLAN classifier groups (1 through 16) can contain any number of VLAN classifier rules.
To configure a VLAN classifier group and add a VLAN classifier rule, perform the following steps
from privileged EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
2. Create a VLAN classifier group and add a rule.
switch(config)#vlan classifier group 1 add rule 1