Filter
Top Products
138 Converged Enhanced Ethernet Administrator’s Guide
53-1002163-02
Brocade 8000 Replacement
A
Effective Configuration:
cfg: host1_fcoe
zone: w2k3_cna1:
21:01:00:00:c8:98:ab:78
……output truncated ….
new_switch:admin> cfgactvshow
Effective Configuration:
cfg: host1_fcoe
zone: w2k3_cna1:
21:01:00:00:c8:98:ab:78
……output truncated ….
12. Bring the new switch back online.
new_switch:admin> switchenable
13. Copy the ethernet settings of the original switch, using copy startup-config and copy
running-config, to an FTP device.
original_switch:admin#cmsh
original_switch#copy startup-config ftp://admin@10.10.10.10/file1
Source password[]?
Building configuration...
original_switch#copy running-config ftp://admin@10.10.10.10/file2
Source password[]?
Building configuration...
14. Upload the startup-config file to the new switch.
new_switch:admin#cmsh
new_switch#copy ftp://admin@10.10.10.10/file1 startup-config
15. Upload the running-config file to the new switch.
new_switch#copy ftp://admin@10.10.10.10/file2 running-config
Source password[]?
Building configuration…
NOTE
In the examples above, the IP address of the FTP server is listed as ’10.10.10.10’ – you must
enter the correct IP address of your FTP server.
16. To verify the Ethernet configuration has been downloaded successfully to the replacement
switch, use the show running-config command on both switches to ensure the running
configurations match.
original_switch#show running-config
!
Protocol spanning-tree rstp
!
vlan classifier rule 1 proto fcoe encap ethv2
vlan classifier rule 2 proto fip encap ethv2
vlan classifier group 1 add rule 1
vlan classifier group 1 add rule 2
!
………….output truncated ……
original_switch#exit
new_switch#show running-config