Brocade Communications Systems 6650 Switch User Manual


 
184 Brocade ICX 6650 Security Configuration Guide
53-1002601-01
Displaying 802.1X information
none – Use no authentication. The client is automatically authenticated without the device using
information supplied by the client.
NOTE
If you specify both radius and none, make sure radius comes before none.
Displaying 802.1X information
You can display the following 802.1X-related information:
The 802.1X configuration on the device and on individual ports
Statistics about the EAPOL frames passing through the device
802.1X-enabled ports dynamically assigned to a VLAN
User-defined and dynamically applied MAC address filters and IP ACLs currently active on the
device
The 802.1X multiple-host configuration
Displaying 802.1X configuration information
To display information about the 802.1X configuration on the Brocade device, enter the show dot1x
command.
Syntax: show dot1x
The following table describes the information displayed by the show dot1x command.
TABLE 32 Output from the show dot1x command
Field Description
PAE Capability The Port Access Entity (PAE) role for the Brocade device. This is always
“Authenticator Only”.
system-auth-control Whether system authentication control is enabled on the device. The
dot1x-enable command enables system authentication control on the device.
re-authentication Whether periodic re-authentication is enabled on the device. Refer to
“Configuring periodic re-authentication” on page 175.
When periodic re-authentication is enabled, the device automatically
re-authenticates Clients every 3,600 seconds by default.
Brocade# show dot1x
PAE Capability: Authenticator Only
system-auth-control: Enable
re-authentication: Disable
global-filter-strict-security: Enable
quiet-period: 60 Seconds
tx-period: 30 Seconds
supptimeout: 30 Seconds
servertimeout: 30 Seconds
maxreq: 2
re-authperiod: 3600 Seconds
Protocol Version: 1