Brocade Communications Systems 6650 Switch User Manual


 
262 Brocade ICX 6650 Security Configuration Guide
53-1002601-01
Example port authentication configurations
Example 1— Multi-device port authentication with dynamic VLAN assignment
Figure 11 illustrates multi-device port authentication with dynamic VLAN assignment on a Brocade
device. In this configuration, a PC and an IP phone are connected to a hub, which is connected to
port e1/1/1 on a Brocade device. Port e1 is configured as a dual-mode port. Also,
mac-authentication disable-ingress-filtering is enabled on the port. The profile for the PC MAC
address on the RADIUS server specifies that the PC should be dynamically assigned to VLAN 102,
and the RADIUS profile for the IP phone specifies that it should be dynamically assigned to VLAN 3.
FIGURE 11 Using multi-device port authentication with dynamic VLAN assignment
In this example, multi-device port authentication is performed for both devices. If the PC is
successfully authenticated, dual-mode port e1 PVID is changed from the VLAN 1 (the
DEFAULT-VLAN) to VLAN 102. If authentication for the PC fails, then the PC can be placed in a
specified “restricted” VLAN, or traffic from the PC can be blocked in hardware. In this example, if
authentication for the PC fails, the PC would be placed in VLAN 1023, the restricted VLAN.
If authentication for the IP phone is successful, then dual-mode port e1/1/1 is added to VLAN 3. If
authentication for the IP phone fails, then traffic from the IP phone would be blocked in hardware.
(Devices sending tagged traffic cannot be placed in the restricted VLAN.)
NOTE
This example assumes that the IP phone initially transmits untagged packets (for example, CDP or
DHCP packets), which trigger the authentication process on the Brocade device and client lookup
on the RADIUS server. If the phone sends only tagged packets and the port (e1/1/1) is not a
member of that VLAN, authentication would not occur. In this case, port e1 must be added to that
VLAN prior to authentication.
The part of the running-config related to multi-device port authentication would be as follows.
Hub
Brocade Switch
Port e1/1/1
Dual Mode
Hub
Untagged
Tagged
RADIUS Server
Tunnel-Private-Group-ID:
User 0000.007f.2e0a -> “U:102”
User 0000.008e.86ac -> “T:3”
PC
M
AC: 0000.007f.2e0a
IP Phone
MAC: 0000.008e.86ac